Bike Wall Mount

Bikes take floor space that a wall could carry. Be realistic about load though: a road bike is around 8 kg and a full-suspension e-bike can be 25 kg, which is well past what printed plastic should hold alone.

Fits: Road, hybrid and light mountain bikes

Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.

Customize in Cadio →

Key dimensions

Hook opening	45 mm for most frame tubes
Back plate	100 × 120 mm, 10 mm thick
Screws	2 × 6 mm into studs
Load	Up to 12 kg in PETG
Padding	Recess for a rubber sleeve

Print settings

Material	PETG minimum — this is a load-bearing part
Layer height	0.2 mm
Walls	5 perimeters
Infill	60%
Supports	None if printed back-down
Orientation	Back plate on the bed — critical for strength

What actually matters

Orientation is not optional here. Printed back-plate-down the layers resist the shear load; printed on its side the hook peels apart at a layer line under a bike's weight.
Screw into studs. Drywall anchors and a hanging bike is how you get a hole in your wall and a damaged bike.
For an e-bike, do not use printed plastic. Buy a steel hanger — 25 kg is beyond what this should carry.

Questions

How much weight can it really take?

Around 12 kg in PETG with five perimeters and 60% infill, mounted into a stud. That covers most road and hybrid bikes, not e-bikes.

Will it scratch the frame?

Line the hook with a rubber sleeve or heat-shrink. Bare plastic against paint marks over time.

Need it in a different size, or with more slots?

Generate your version →