Adhesive Cable Clips

The smallest useful print there is: a clip that holds a charging cable at the desk edge so it does not fall behind every time you unplug. Prints in minutes and solves a daily irritation.

Fits: Cables 3–8 mm diameter

Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.

Customize in Cadio →

Key dimensions

Channel	Sized per cable, 3–8 mm
Base	22 × 18 mm adhesive pad
Height	14 mm
Set	Six clips
Print time	Around 20 minutes for six

Print settings

Material	PETG — slight flex helps the clip grip
Layer height	0.2 mm
Walls	3 perimeters
Infill	30%
Supports	None
Orientation	Base on the bed, opening up

What actually matters

Size the channel slightly smaller than the cable so it clips in rather than falls out — about 0.5 mm under works well.
Clean the desk with alcohol before sticking. Adhesive failure on these is almost always a dusty surface.
Print a mixed set of sizes in one go. A USB-C cable and a monitor cable need very different channels.

Questions

Will the adhesive damage my desk?

Standard mounting tape lifts cleanly from sealed wood and laminate. Test on an unseen spot for delicate finishes.

Can I screw them instead?

Generate a version with a screw hole if you want something permanent.

Need it in a different size, or with more slots?

Generate your version →