Models › Pets
Pets
Raised Pet Bowl Stand
Raised bowls suit larger dogs and older pets because they do not have to stoop, and they stop the bowl skating across the floor. Height is the thing to get right — roughly at the animal's chest, not its head.
Fits: Standard 160–200 mm pet bowls
Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.
Customize in Cadio →Key dimensions
| Bowl recess | 175 mm diameter |
| Stand height | 150 mm — adjust to your pet |
| Bowls | 2 |
| Footprint | 420 × 220 mm |
| Wall thickness | 3 mm |
Print settings
| Material | PETG — gets washed constantly |
| Layer height | 0.25 mm |
| Walls | 3 perimeters |
| Infill | 25% |
| Supports | None |
| Orientation | Top face down for a clean surface |
What actually matters
- Measure your pet, not just the bowls. The bowl rim should sit around chest height — too high is as bad as too low.
- Keep the stainless or ceramic bowls and print only the stand. Pets should not eat directly off printed plastic — layer lines trap food residue.
- A wide footprint stops an enthusiastic dog from tipping the whole thing.
Questions
Is printed plastic safe for pets?
The stand is fine because food never touches it. Use proper bowls rather than printing the bowl itself.
What height should I use?
Roughly the height of your pet's chest when standing. Generate to that measurement rather than guessing.
Need it in a different size, or with more slots?
Generate your version →