Models › Desk
Desk
Adjustable Phone Stand
Viewing angle is the whole design. Around 65° suits a phone sat on a desk you look down at; 50° is better for video calls where the camera needs to see your face rather than your ceiling. A cable channel means you can charge while it sits there.
Fits: Phones up to 12 mm thick, with or without a case
Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.
Customize in Cadio →Key dimensions
| Angle | 65° from horizontal |
| Lip depth | 12 mm — clears a thick case |
| Cable channel | Cut through the lip |
| Footprint | 90 × 80 mm |
| Weight | Prints in under 30 g |
Print settings
| Material | PLA |
| Layer height | 0.2 mm |
| Walls | 3 perimeters |
| Infill | 15% |
| Supports | None — the geometry is self-supporting |
| Orientation | Back face on the bed |
What actually matters
- Print the back face down and the angled front becomes a self-supporting overhang, so you avoid supports and the visible surface stays clean.
- Add a strip of TPU or a rubber pad to the lip if your phone slides. Bare PLA against glass is slippery.
- For video calls, regenerate at 50° instead — 65° points the camera at your ceiling.
Questions
Will it hold a tablet?
Not this size. A tablet needs a deeper lip and a much wider base or it topples backwards. Generate a tablet stand instead.
Can I charge while it is in the stand?
Yes — the cable channel runs through the lip so the connector clears the stand.
Need it in a different size, or with more slots?
Generate your version →