Plant Pot Drainage Feet

A pot sitting flat in its saucer leaves roots standing in water, which is what actually kills most indoor plants. Lifting it 15 mm lets water drain away and air reach the base, and outdoors it stops the ring stain on decking.

Fits: Any pot up to 400 mm diameter

Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.

Customize in Cadio →

Key dimensions

Height	15 mm
Contact pad	30 mm diameter
Load	Four feet carry a large ceramic pot
Surface	Flat top, no rocking
Set	Four per pot

Print settings

Material	PETG indoors, ASA or PETG outdoors
Layer height	0.2 mm
Walls	3 perimeters
Infill	40% — these carry real weight
Supports	None
Orientation	Flat, straight off the bed

What actually matters

Do not use PLA outdoors. It absorbs moisture, goes brittle in UV, and a foot that fails drops a heavy ceramic pot.
Four feet, not three. Three is stable in theory but pots are rarely flat underneath and three feet rock.
Higher is not better indoors — above about 20 mm the pot becomes easy to knock off.

Questions

Will they mark my floor?

Add a felt pad to the base if the pot sits on wood. Bare plastic under a heavy pot can scuff over time.

Can I use them for very heavy pots?

Increase the pad diameter and infill for large ceramics. Point loads on a small pad are what crack a foot.

Need it in a different size, or with more slots?

Generate your version →